|
|||||||||||||||||||
| KIT FEATURES Heavy 24 kt gold plating with epoxy coating • Smooth click operation / new improved “Super-Feed” lead mechanism • Made to match as a set with pen components • Contemporary clip design • Designed to show maximum wood exposure • Uses 0.7mm lead • Overall length : 5 11/16" |
REQUIRED ACCESSORIES |
Diagram A: Pencil Parts
Notes: |
|
| PREPARING THE BLANKS • Use 5/8" square blanks (or pre-drilled super blanks to avoid the drilling process) • Cut the blanks down to the size of the brass tubes. (add 1/16" for squaring off) • Drill a 7mm hole, lengthwise through each blank • Spread glue over the tubes. Insert into the blanks with a twisting motion to spread the glue evenly inside. Center tubes lengthwise in the blanks. • When glue dries, use a barrel trimmer to square the ends of each blank. Take the wood down, flush to the brass tube. |
|
| Diagram B: Turning The
Blanks |
|
| TURNING THE BLANKS |
|
Diagram C: Pencil Assembly |
|
| PENCIL ASSEMBLY • Press the extension of the center band into the wide end of the front barrel. • Press the opposite end of the band extension into the long barrel. • Insert the cap into the clip. Press this assembly into the open end of the long barrel. • Insert and press the sleeve, wide recessed end in first into the front end of the front barrel. • Insert the pencil mechanism, tip end in first through the cap until the tread is showing through the sleeve. • Screw on the tip end tight. • Click the plunger gently for the lead to extend. Click and hold down plunger, push the lead back into the mechanism to retract the lead. • Pull the plunger cap out to use the eraser. • To replace or add lead, just pull the eraser out and drop 0.7mm leads into the storage compartment. Place the plunger cap back. Click until new lead is exposed. |
|
| BUSHING
SET:#PK-1408 ![]() |
|
|
||||||||||||||||||||
|
|
||||||||||||||||||||