|
|||||
 |
|||||
 |
Pen Disassembler Tool For “Slimline” and “Comfort” pens PK-1121 |  |
|||
|
|||||||||||||||||||
|
|
|
|
| 1) Disassemble the pen – Cap/clip barrel, band, refill,
and lower barrel. |
3) Hold the barrel tightly in your fist while tapping on the
end of the shaft with a hammer. Sharp forceful taps will dislodge the tip. 4) Continue until the tip is pushed free from the barrel. Be careful not to lose the tip if it flies off the pen barrel. |
| |
|
| 5) After the tip is off the pen,
use the thicker Shaft "B" to remove the pen mechanism. Place this
shaft into the barrel where you just removed the tip. 6) Insert the pen mechanism into the retainer from the tapered end, making sure that the retainer makes contact with only the brass tube end, not the turned material. |
7) Now center this set-up between
the jaws of a bench vise. 8) Squeeze slowly as the pen mechanism is forced into the retainer. |
| |
|
| 9) Separate all parts, and proceed to remove
the pen cap and pocket clip. 10) Insert the large Shaft "B" into the barrel up against the cap. |
11) Hold the barrel tightly in your fist while
tapping on the end of the shaft with a hammer. Sharp forceful taps will
dislodge the cap and clip. 12) Continue until the cap and clip are pushed free from the barrel. Be careful not to lose these parts if they fly off the pen barrel. |
|
||||||||||||||||||||
|
|
||||||||||||||||||||
